IPPC-registered heat treatment of packaging timber, crate components, skids and dunnage to the ISPM 15 standard. 56°C core for 30 minutes, IPPC mark applied, and a treatment record issued for every batch. Est. 1955.
Most countries refuse, fumigate or destroy solid wood packaging that arrives without a valid ISPM 15 mark. The cost falls on the exporter, and the delay can cost the contract. Heat treatment by a registered facility removes that risk for a small cost per item. We are a timber treatment facility, not a packaging maker: bring us your packaging timber or finished wooden packaging and we treat, mark and document it. Read our guide to ISPM 15 and the exporter’s certification checklist, or combine treatment with kiln drying.
Verified at the core of the thickest piece
ISPM 15 heat treatment kills all life stages of regulated pests, including eggs, larvae and adults, by holding the core of every piece at 56°C for at least 30 continuous minutes. We verify core temperature with calibrated probes placed in the thickest pieces of each load.
Your timber, treated and marked
Packaging makers bring us sawn timber before assembly. Exporters bring finished crates, skids and loose dunnage. Both leave treated, marked and documented. We treat the timber; we do not make or sell the packaging.
Ready for customs inspection
Each treated item carries the IPPC mark with country code LK, our facility registration number and the HT code. Each batch gets a treatment record with date, parameters and quantity for your shipping file.
The whole cross-section of the wood must reach a core temperature of 56°C and hold it for at least 30 continuous minutes, verified by probes in the thickest pieces. The treatment must be done by an IPPC-registered facility, and each item is then marked with the IPPC mark.
Solid wood used for export packaging: sawn packaging timber, crate and box components, skids, bearers, blocks and loose dunnage. Bring us the timber before assembly, or finished wooden packaging, and we treat and mark it. We are a treatment facility; we do not manufacture or sell packaging.
The IPPC symbol, the country code (LK), the treating facility’s unique registration number, and the treatment code HT for heat treatment. Customs inspectors at the destination port check this mark; an absent or incorrect mark is treated the same as untreated wood.
Yes. Every batch receives a treatment record showing the date, treatment parameters and quantity. Keep it with your shipping documents.
The heat cycle itself is short, but chamber scheduling, marking and transport take time. Contact us with your volume and shipping date as early as possible and we will schedule around your deadline.
No. Processed wood products such as plywood, particle board, OSB and MDF are exempt from ISPM 15 because the manufacturing process already removes the pest risk. The standard applies to solid wood packaging material.
Yes, if the repair uses untreated wood. Packaging repaired with an unmarked board is no longer compliant and must be re-treated and re-marked before it can be used for export.
Send us the timber or packaging type, dimensions, quantity and shipping date. We will confirm a chamber slot and reply with a quote, usually within a few hours.